Cause stripping wire processing bad what?
Classification: Industry knowledge
In the process of our wire harness processing, what causes poor peeling? It may be explained in words, but you still can't fully understand it. Today, we'll explain it to you in the way of pictures and text.
Generally, there are the following important reasons
(1) There are no operating essentials for installing machinery, and the operation is correct.
(2) Incorrect adjustment of tool distance
(3) Finally, the knife edge is damaged.
See the following breakdown for specific bad pictures and causes
This situation is often related to the blunt knife of the incision, or the knife distance is incorrect
The second situation is that the incision is uneven and the knife is blunt
The third case is that the copper wire is damaged or broken, and the knife distance is too small
The fourth case is that there is an insulating layer on the conductor, the knife is blunt or the knife distance is adjusted too much
The fifth case is that the insulating layer is damaged and there are hard objects in the stripping clamp
The sixth case is loose wire
The seventh case is that the wire is too tight